Skip to content

Bob Baddeley

Menu
  • About Me
  • Contact
  • Resume
    • Publications
  • Projects
    • Personal
    • WYZGYZ
    • Propeller Health
    • Wacky Dancers
    • Hackaday
    • Allergy Amulet
    • Quietyme
    • BlueTipz
    • Portable Scores
    • PNNL
    • Oregon State University
    • University Of Great Falls
Menu

Parallel Pis for Production Programming; Cutting Minutes and Dollars Off of Assembly

December 30, 2019August 26, 2020

Assembly lines for electronics products are complicated beasts, often composed of many custom tools and fixtures. Typically a microcontroller must be programmed with firmware, and the circuit board tested before assembly into the enclosure, followed by functional testing afterwards before putting it in a box. These test platforms can be very expensive, easily into the tens of thousands of dollars. Instead, this project uses a set of 12 Raspberry Pi Zero Ws in parallel to program, test, and configure up to 12 units at once before moving on to the next stage in assembly.

Read the full article at Hackaday: Parallel Pis for Production Programming; Cutting Minutes and Dollars Off of Assembly

Leave a Reply Cancel reply

You must be logged in to post a comment.

Bob Baddeley

I am a computer engineer experienced in developing products from proof of concept through mass production. I want to have a positive impact on the world.

Search

Recent Posts

  • Recovering a Water Bottle
  • Heat Pump Water Heater Installation
  • Bibimbob
  • Do Treehouses Need Permits?
  • Aurora Borealis in my Backyard!

Categories

  • Building
  • Computers
  • Cooking
  • Hackaday
  • Panoramas
  • Personal Projects
  • Skydiving
  • Sports
  • Uncategorized
© 2025 Bob Baddeley | Powered by Superbs Personal Blog theme